On 04/07/2017 06:48 PM, Sergei Shtylyov wrote: > Hello! > > On 04/07/2017 05:30 PM, Niklas Cassel wrote: > >> From: Niklas Cassel <niklas.cas...@axis.com> >> >> The hardware has a LPI interrupt. >> There is already code in the stmmac driver to parse and handle the >> interrupt. However, this information was missing from the DT binding. >> >> Signed-off-by: Niklas Cassel <niklas.cas...@axis.com> >> --- >> Documentation/devicetree/bindings/net/stmmac.txt | 8 ++++---- >> 1 file changed, 4 insertions(+), 4 deletions(-) >> >> diff --git a/Documentation/devicetree/bindings/net/stmmac.txt >> b/Documentation/devicetree/bindings/net/stmmac.txt >> index f652b0c384ce..8977abc266ac 100644 >> --- a/Documentation/devicetree/bindings/net/stmmac.txt >> +++ b/Documentation/devicetree/bindings/net/stmmac.txt >> @@ -8,8 +8,8 @@ Required properties: >> that services interrupts for this device >> - interrupts: Should contain the STMMAC interrupts >> - interrupt-names: Should contain the interrupt names "macirq" >> - "eth_wake_irq" if this interrupt is supported in the "interrupts" >> - property >> + "eth_wake_irq" if this interrupt is supported in the "interrupts property > > Missed closing quote?
Thanks for pointing it out. Will send a v2. > >> + "eth_lpi" if this interrupt is supported in the "interrupts" property >> - phy-mode: See ethernet.txt file in the same directory. >> - snps,reset-gpio gpio number for phy reset. >> - snps,reset-active-low boolean flag to indicate if phy reset is active low. > [...] > > MBR, Sergei >
