Hi Andrew,

> > We would need a tri-state device tree properly:
> > 
> > 1. Not defined - do nothing
> > 2. Defined as 0 -> explicitly disable port mirroring
> > 3. Defined as 1 -> explicitly enable port mirriring
> > 
> > The "net-phy-lane-swap" only fulfills points 1 and 3 above.
> > 
> > In my use case I do need point 2.
> 
> Looking at the datasheet, PORT_MIRROR_EN defaults to 0. So it seems
> reasonable to unconditionally set it to 0 when the PHY driver
> loads. Any device which needs a value of 1 can set "net-phy-lane-swap"

Unconditionally setting this field to 0 (as we expect the reset default
setting) seems to me like a good solution. 

However, I was not sure if such approach is acceptable by the community.

> 
>        Andrew




Best regards,

Lukasz Majewski

--

DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de

Reply via email to