On Mon, Nov 28, 2016 at 02:24:30PM +0100, Allan W. Nielsen wrote:
> From: Raju Lakkaraju <[email protected]>
>
> 3 types of PHY loopback are supported.
> i.e. Near-End Loopback, Far-End Loopback and External Loopback.
Hi Allan
Is this integrated with ethtool --test? You only want the PHY to go
into loopback mode when running ethtool --test external_lb or maybe
ethtool --test offline.
What i think should happen is that this tunable sets the mode the PHY
will go into when loopback is enabled. It does not however enable
loopback. It is running ethtool --test which actually enables the
loopback, probably by setting BMCR_LOOPBACK. Once the test is
finished, the bit is cleared and the PHY goes back into normal
operation.
Andrew
