If the PHY has been configured to allow pause frames, then the MAC
should be configured to generate and/or accept those frames.

Signed-off-by: Timur Tabi <ti...@codeaurora.org>
---
 drivers/net/ethernet/qualcomm/emac/emac-mac.c | 10 ++++++----
 1 file changed, 6 insertions(+), 4 deletions(-)

diff --git a/drivers/net/ethernet/qualcomm/emac/emac-mac.c 
b/drivers/net/ethernet/qualcomm/emac/emac-mac.c
index 70a55dc..46e19e9 100644
--- a/drivers/net/ethernet/qualcomm/emac/emac-mac.c
+++ b/drivers/net/ethernet/qualcomm/emac/emac-mac.c
@@ -575,10 +575,12 @@ void emac_mac_start(struct emac_adapter *adpt)
 
        mac |= TXEN | RXEN;     /* enable RX/TX */
 
-       /* We don't have ethtool support yet, so force flow-control mode
-        * to 'full' always.
-        */
-       mac |= TXFC | RXFC;
+       /* Configure MAC flow control to patch the PHY's settings */
+       if (phydev->pause)
+               mac |= RXFC;
+
+       if (!phydev->pause && phydev->asym_pause)
+               mac |= TXFC;
 
        /* setup link speed */
        mac &= ~SPEED_MASK;
-- 
Qualcomm Datacenter Technologies, Inc. as an affiliate of Qualcomm
Technologies, Inc.  Qualcomm Technologies, Inc. is a member of the
Code Aurora Forum, a Linux Foundation Collaborative Project.

Reply via email to