Hi I’m evaluating ENC28J60 for a new design, so I’ve got myself a module from ebay and verified that it works perfectly with Raspberry Pi.
Now I’m trying to get it to work on a Beaglebone (Beaglebone Green Wireless). After some struggles the device tree seems right and I’ve checked all signals (CS, MOSI, MISO, CLK, INT) with an oscilloscope and it looks perfect. SPI max frequency is set to a low value: 100 kHz. The driver is loaded and the device is detected and after boot I have an eth0 interface. But I can’t get it to link up state. I’ve now enabled lots of debug messages and first thing I noticed is that the hardware revision (EREVID) is consistently reported as 0x3C. I’ve not seen any mentions of hardware revisions above 7 so that looks suspicios. Do you think you could help me there? What is the expected EREVID? I’ve seen other people having trouble with ENC28J60 + Beaglebone on the web, but I’m not ready to give up that easily... Here’s output of enc28j60_dump_regs: [ 9.083081] enc28j60: Enter enc28j60_dump_regs [ 9.143364] enc28j60 Hw initialized. [ 9.143364] HwRevID: 0x3c [ 9.143364] Cntrl: ECON1 ECON2 ESTAT EIR EIE [ 9.143364] 0x0f 0xc0 0x03 0x00 0x00 [ 9.143364] MAC : MACON1 MACON3 MACON4 [ 9.143364] 0xf3 0x0c 0x00 [ 9.143364] Rx : ERXST ERXND ERXWRPT ERXRDPT ERXFCON EPKTCNT MAMXFL [ 9.143364] 0x0000 0xc3ff 0x0000 0xc3ff 0x03 0x00 0x33fc [ 9.143364] Tx : ETXST ETXND MACLCON1 MACLCON2 MAPHSUP [ 9.143364] 0xcc00 0xffff 0xff 0x3f 0x00 Best regards, Jonatan Magnusson
