On 16-07-20 01:00 PM, ivan wrote: > Hi everyone. > > The ethtool interface has ETHTOOL_PERQUEUE command that is used to > read/set per-queue parameters for multiqueue Ethernet devices. > > I want to apply additional per-queue commands like per-queue bandwidth > and per-queue number of descriptors (like number of rings). > > Currently only ETHTOOL_G/SCOALESCE sub commands are added for > per-queue interface (but I haven't seen counterpart for ethtool util). > > Using ETHTOOL_G/SCOALESCE per-queue command as an example, > I'm going to add 2 additional and 2 known commands for ethtool > per-queue interface: > > ETHTOOL_G/SBANDWIDTH /* Get/Set ethtool per queue bandwidth. > Bandwidth can be set with % or absolute in Mb/s */ >
For tx rate limiting we have an ndo op for this already, ndo_set_tx_maxrate which can be tuned via sysfs at the moment. It would logically make sense to add an rx rate limit if you are looking for something more like a policer. Or do this via setup_tc() interface as we do with mqprio qdisc today. If you are interested in max and min rates per queue groups one such possibility being a queue group of one you may find the ./net/dcb stack interesting as well. Although the DCB spec has lots of bits about protocols and such the kernel interfaces do not care if the protocol is running at all. Unfortunately when this was done originally we didn't make this as clear as we should have. .John
