Adding the missing link advertise for some X710 NICs.
This can be observed by simply calling ethtool on the interface.
root@rhel7:~ # ethtool eth0
Settings for eth0:
Supported ports: [ FIBRE ]
Supported link modes: 10000baseT/Full
Supported pause frame use: Symmetric
Supports auto-negotiation: No
Advertised link modes: Not reported
[...]
With fix applied.
root@rhel7:~ # ethtool eth0
Settings for eth0:
Supported ports: [ FIBRE ]
Supported link modes: 10000baseT/Full
Supported pause frame use: Symmetric
Supports auto-negotiation: No
Advertised link modes: 10000baseT/Full
[...]
Signed-off-by: Stefan Assmann <sassm...@kpanic.de>
---
drivers/net/ethernet/intel/i40e/i40e_ethtool.c | 1 +
1 file changed, 1 insertion(+)
diff --git a/drivers/net/ethernet/intel/i40e/i40e_ethtool.c
b/drivers/net/ethernet/intel/i40e/i40e_ethtool.c
index 5e8d84f..88ef7cb 100644
--- a/drivers/net/ethernet/intel/i40e/i40e_ethtool.c
+++ b/drivers/net/ethernet/intel/i40e/i40e_ethtool.c
@@ -453,6 +453,7 @@ static void i40e_get_settings_link_up(struct i40e_hw *hw,
case I40E_PHY_TYPE_10GBASE_SFPP_CU:
case I40E_PHY_TYPE_10GBASE_AOC:
ecmd->supported = SUPPORTED_10000baseT_Full;
+ ecmd->advertising = SUPPORTED_10000baseT_Full;
break;
case I40E_PHY_TYPE_SGMII:
ecmd->supported = SUPPORTED_Autoneg |
--
2.5.5
