When reopening the network device on ra7795/salvator-x, e.g. after a
DHCP timeout:
IP-Config: Reopening network devices...
genirq: Flags mismatch irq 139. 00000000 (eth0:ch24:emac) vs. 00000000
(eth0:ch24:emac)
ravb e6800000.ethernet eth0: cannot request IRQ eth0:ch24:emac
IP-Config: Failed to open eth0
IP-Config: No network devices available
The "mismatch" is due to requesting an IRQ that is already in use,
while IRQF_PROBE_SHARED wasn't set.
However, the real cause is that ravb_close() doesn't release the R-Car
Gen3-specific secondary IRQ.
Add the missing free_irq() call to fix this.
Fixes: 22d4df8ff3a3cc72 ("ravb: Add support for r8a7795 SoC")
Signed-off-by: Geert Uytterhoeven <[email protected]>
---
This version is against net.git.
v2:
- New.
---
drivers/net/ethernet/renesas/ravb_main.c | 2 ++
1 file changed, 2 insertions(+)
diff --git a/drivers/net/ethernet/renesas/ravb_main.c
b/drivers/net/ethernet/renesas/ravb_main.c
index 9e2a0bd8f5a88803..4277d0c12101fef7 100644
--- a/drivers/net/ethernet/renesas/ravb_main.c
+++ b/drivers/net/ethernet/renesas/ravb_main.c
@@ -1506,6 +1506,8 @@ static int ravb_close(struct net_device *ndev)
priv->phydev = NULL;
}
+ if (priv->chip_id == RCAR_GEN3)
+ free_irq(priv->emac_irq, ndev);
free_irq(ndev->irq, ndev);
napi_disable(&priv->napi[RAVB_NC]);
--
1.9.1
