Hi All,
first tentative to write a bug report
Asus motherboard K8SMV with integrated SIS190 ethernet driver
vanilla kernel 2.6.15 (but the same also for .14) on Fedora 4
The SIS190 works sending data out but hangs around 90K when
receiving data in. No problem at all with the additional 8139 board
I noted the same also with scp but for a clean test I used
vsftp on the ASUS, ncftp-cygwin on a laptop with 100Mbit
direct twisted cable and tried to move a large file in both directions
out 37.68 MB at 6.32 MB/s OK
receive hangs around 90K
I see no relevant message on /var/log/messages
and from lurking and googling I had the impression that there are no
SIS190 on ASUS really working.
Additional note, when the cable is not connected the driver bores me
with a long list of this message
kernel: eth1: PHY reset until link up
any suggestion or further test to be tried is welcomed
#######################################
System info :
Linux version 2.6.15 ([EMAIL PROTECTED])
(gcc version 4.0.2 20051125 (Red Hat
4.0.2-8)) #7 PREEMPT Tue Jan 3 19:31:16 CET 2006
vendor_id : AuthenticAMD
cpu family : 15
model : 12
model name : AMD Athlon(tm) 64 Processor 3200+
filtred /var/log/messages at boot
kernel: 8139too Fast Ethernet driver 0.9.27
kernel: ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 5
kernel: PCI: setting IRQ 5 as level-triggered
kernel: ACPI: PCI Interrupt 0000:00:0a.0[A] -> Link [LNKB] -> GSI 5
(level, low) -> IRQ 5
kernel: eth0: RealTek RTL8139 at 0x8400, 00:06:7b:03:cf:42, IRQ 5
kernel: sis190 Gigabit Ethernet driver 1.2 loaded.
kernel: ACPI: PCI Interrupt Link [LNKD] enabled at IRQ 5
kernel: ACPI: PCI Interrupt 0000:00:04.0[A] -> Link [LNKD] -> GSI 5
(level, low) -> IRQ 5
kernel: 0000:00:04.0: Read MAC address from APC.
kernel: 0000:00:04.0: Realtek PHY RTL8201 transceiver at address 1.
kernel: 0000:00:04.0: Using transceiver at address 1 as default.
kernel: 0000:00:04.0: SiS 190 PCI Fast Ethernet adapter at f8806c00 (IRQ: 5),
00:13:d4:16:a8:bb
kernel: eth1: GMII mode.
kernel: eth1: Enabling Auto-negotiation.
filtred lsmod:
sis190 15876 0
8139too 20160 0
filtred lspci -vvv
00:04.0 Ethernet controller: Silicon Integrated Systems [SiS]:
Unknown device 0190
Subsystem: ASUSTeK Computer Inc.: Unknown device 8139
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium
>TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 0
Interrupt: pin A routed to IRQ 5
Region 0: Memory at fbefbc00 (32-bit, non-prefetchable)
[size=128]
Region 1: I/O ports at b000 [size=128]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA
PME(D0+,D1+,D2+,
D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
filtred lspci -xxx
00:04.0 Ethernet controller: Silicon Integrated Systems [SiS]:
Unknown device 0190
00: 39 10 90 01 07 00 10 02 00 00 00 02 00 00 00 00
10: 00 bc ef fb 01 b0 00 00 00 00 00 00 00 00 00 00
20: 00 00 00 00 00 00 00 00 00 00 00 00 43 10 39 81
30: 00 00 00 00 40 00 00 00 00 00 00 00 05 01 00 00
40: 01 00 02 fe 00 00 00 00 00 00 00 00 00 00 00 00
50: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
60: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
70: 00 00 80 f5 00 00 00 00 00 00 00 00 04 05 00 00
80: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
90: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
a0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
b0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
c0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
d0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
e0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
f0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
Regards
Marco
--
marco.atzeri at fastwebnet.it
La prima delle Frequently Asked Questions:
dove sono le FAQ ? it.faq
-
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
