On Sat, Jun 05, 2010 at 05:50:39PM -0500, Neal Hogan wrote: > On Sat, Jun 5, 2010 at 5:27 PM, Edho P Arief <[email protected]> wrote: > > On Sun, Jun 6, 2010 at 5:14 AM, Neal Hogan <[email protected]> wrote: > >> Hello, > >> > >> I just tried to upgrade my machine to 4.7 (release) and it IDs my hard > >> drives differently than 4.6 did. That is, when asked (during upgrade) > >> which disk the root partition is on it offers: sd0 wd0 wd1 wd2. > >> However, what I'm expecting is: wd0 wd1 wd2 wd3 > >> > >> Thus, fsck fails and therefore the upgrade does too. Will upgrading > >> via source work? Fresh install? Note that I tried ramdisks from two > >> different mirrors and was attempting a net install. I found no > >> discussion/docs concerning this . . . I'm not even sure what to search > >> for. > >> > > > >> OpenBSD 4.6 (GENERIC.MP) #81: Thu Jul 9 21:26:19 MDT 2009 > >> pciide0 at pci0 dev 17 function 0 "ATI SBx00 SATA" rev 0x00: DMA > >> (unsupported), channel 0 configured to native-PCI, channel 1 > >> configured to native-PCI > >> pciide0: using apic 4 int 22 (irq 10) for native-PCI interrupt > >> pciide0: channel 0 ignored (not responding; disabled or no drives?) > >> wd0 at pciide0 channel 1 drive 0: <ST3750528AS> > >> wd0: 16-sector PIO, LBA48, 715404MB, 1465149168 sectors > > > > > >> OpenBSD 4.7 (GENERIC.MP) #130: Wed Mar 17 20:48:50 MDT 2010 > >> ahci0 at pci0 dev 17 function 0 "ATI SBx00 SATA" rev 0x00: apic 4 int > >> 22 (irq 10), AHCI 1.1 > >> scsibus0 at ahci0: 32 targets > >> sd0 at scsibus0 targ 1 lun 0: <ATA, ST3750528AS, CC38> SCSI3 0/direct > fixed > >> sd0: 715404MB, 512 bytes/sec, 1465149168 sec total > > > > > > In short: AHCI support for your SATA controller was added. Upgrade and > > modify fstab accordingly. > > > > > > OK . . . but I have another SATA drive. > > wd0 at pciide0 channel 0 drive 1: <ST3500418AS> > wd0: 16-sector PIO, LBA48, 476940MB, 976773168 sectors > wd0(pciide0:0:1): using PIO mode 4, DMA mode 2, Ultra-DMA mode 6 > > and it's not ID'ed that way. > > Just to be clear, you mean for me to modify /etc/fstab, then upgrade . > . . right. > > Thanks for the response, Edho.
you probably don't want to edit fstab on a "live" system. shutdown might not be happy. boot bsd.rd and use the (s) option to get a shell. edit your fstab then upgrade (you can use the 'upgrade' command in that shell to start the upgrade script). -- [email protected] SDF Public Access UNIX System - http://sdf.lonestar.org
