Corey J. Bukolt wrote:
> Robert wrote:
>
>> On Wed, 09 Dec 2009 18:38:20 -0600
>> "Corey J. Bukolt" <[email protected]> wrote:
>>
>>
>>
>>> cbb0 at pci0 dev 8 function 0 "O2 Micro OZ69[17]2 CardBus" rev 0x00:
>>> apic 2 int 17 (irq 255), CardBus support disabled
>>>
>>>
>> That's a boot with the card inserted?
>> I guess not by the message at the end of the dmesg.
>>
>> You could try to disable acpi and run with apm.
>> (Normally it is the other way around, so don't get your hopes up.)
>>
>> # sudo config -ef /bsd
>> disable acpi
>> enable apm
>> quit
>> # sudo reboot
>>
>> - Robert
>>
>> .
>>
>>
>>
> Okay, I gave that a try, only now my system hangs during boot, as soon
> as it starts to detect the pcmcia slot.
> This happens even if I boot without the card.
> Here are the last few lines of output:
>
> pcmcia0 at cardslot0
> uvm_fault(0xd088cfc0, 0x9097c000, 0, 1) -> e
> kernel: page fault trap, code=0
> stopped at Xintr_IOapic2+0x35: Mov( apic_maxlevel(,%eax, 4), %ebx
> ddb>
>
> and it gets stranger.
> If I press a key, the following repeats over a few times, and then the
> system locks up entirely.
>
> ddb> PANIC: mtx_enter: locking against myself
> Stopping a t wwwGcJ=0x4: leave
> RUN AT LEAST TRACE AND PS AND INCLUDE OUTPUT WHEN REPORTING THIS PANIC!
> DO NOT EVE BOTHER REPORTING THIS WITHOUT INCLUDING THAT INFORMATION.
>
> Is there a way I can reenable acpi from the bootloader?
> I stupidly neglected to backup my kernel, thinking something like this
> wouldn't happen.
>
>
>
Okay, got the system back to booting after I RTFM'd boot(8)and
boot_config(8).
Sorry, for asking questions before checking the man pages, bad linux
user habit.....
