On Thu, 12 Nov 2009 12:45:24 -0800 rhubbell <[email protected]> wrote:
> I'm new to OpenBSD and so far so good. > One thing I am floundering around on is that I cannot get my 3Com > card working. You're new, so you might want to read the following: http://www.openbsd.org/mail.html [quote] "Include important information Don't waste everyone's time with a hopelessly incomplete question. No one other than you has the information needed to resolve your problem, it is better to provide more information than needed than one detail too little. Any question should include at least the version of OpenBSD (i.e., "3.2-stable", "3.3-current as of July 20, 2003"). Any hardware related questions should mention the platform (i.e., sparc, alpha, etc.), and provide a full dmesg(8)." [/quote] The reason for that last bit about providing a "full dmesg" is the full dmesg shows lots of important details. In a sense, you can think of the full demeg as showing a picture of your full environment. > The device 3CCFE575CT exists already and I added the entries for > 3CXFE575CT. The product model number is not always indicative of the chips used inside the product. But in your case, this is irrelevant. > cbb1 at pci1 dev 4 function 0 "TI PCI1620 CardBus" rev 0x01: apic 2 > int 16 (irq 11), CardBus support disabled > > cbb2 at pci1 dev 4 function 1 "TI PCI1620 CardBus" rev 0x01: apic 2 > int 16 (irq 11), CardBus support disabled Take a look inside /usr/src/sys/dev/pci/pccbvar.h HINT: The "TI PCI1620" is not listed. In short, there might not be anything "wrong" with your 3com card, but instead, the PCMCIA/CardBus controller (i.e. slot) is not supported. -- J.C. Roberts
