Yes, I first started by setting up the raid and installing openBSD on top of it. All was fine until one of the disks failed. Then, I replaced the failed disk, and try to re-initiate the raid (mirroring) where I got stuck since the raid controller did not like the partitioning.
However, I advanced one step further now: If you use fdisk to assign a different id to the openBSD partition (like 83 as suggested by Sun for the Linux installs), raid controller seems to start mirroring your disk to the second one. However, when you change your partition id from the default value of A6 to 83, openBSD could not boot. So, I am planning to play with the partition id so that I could set up the mirroring through LSI raid controller. Once it is done, I will revert the partition id back to its default value of A6. Then I will see if mirroring still works, and boots off of the second disk! Rami Sik -----Original Message----- From: J.C. Roberts [mailto:[EMAIL PROTECTED] Sent: January 29, 2008 1:13 PM To: Rami Sik Cc: [email protected] Subject: Re: openBSD 4.2 and LSI raid On Monday 28 January 2008, Rami Sik wrote: > I did a research and found the similar problem already reported for > Linux installations, and Sun released a workaround for it. However, I > cannot find anything about openBSD installations. At present, I've got two LSI RAID controllers here running OpenBSD ("MegaRAID 150-6 SATA" and "MegaRAID i4" PATA). Though I don't know about your specific controler (1030), the normal answer is to create your logical drive in the controler setup and *THEN* install the operating system. >From your description, it seems you're doing things backwards, namely installing the OS on one drive and then trying to create a miror. -jcr
