On Nov 17, 2007 12:04 AM, Marco Peereboom <[EMAIL PROTECTED]> wrote:
> I'll take this as the documentation isn't good enough. Can you point me
> to the area that isn't clear?
>
Thanks for the offer Marco.
I currently use RAIDFRAME for Raid 1
A few doubts that remain after I have read the man page is.
1) Is it possible to run "/" from a Softraid volume?
2) "Currently the RAID 1 support does not have the ability to recover a failed
chunk."
Does this mean If I have two chunks on two different hard disks and if
one disk fails I need to
a) copy the data from the working disk to some where
b) get a new disk and re create RAID 1 as I did in the begining and
copy back the data to the RAID 1 volume?
3) "The RAID 1 discipline does not initialize the mirror upon creation."
So what should be done manually to initialize the mirror?
Also if the system suffers a power loss will the system boot up only
after parity is checked?
Thank you so much
Kind Regards
Siju
