On 2/19/07, Administrator <[EMAIL PROTECTED]> wrote:
Hi all,
I am having an issue trying to install to a HP ML110 G4.
There was an identical thread a week or so ago that doest seem to have a
solution.
I was hoping someone may have some further suggestions.
I keep getting flooded with these messages during the install
axe0: read PHY failed
axe0: read PHY failed
axe0: read PHY failed
The machine finally gets to the install prompt but becomes unresponsive.
It was suggested to boot -c and disable axe but the machine is also
unresponsive at the ukc prompt.
This is supposed to be on-site tomorrow so any thoughts would be greatly
appreciated.
I got around this by boot -c from a serial console. UKC> prompt works
from there. You can then "disable axe" and boot. Then once you're
up,
# cp -p /bsd /bsd.orig
# config -e -o /bsd /bsd
UKC> disable axe
UKC> quit
and it'll boot.
As per previous thread, your null modem cable must provide DCD;
otherwise, you'll see the boot> prompt, but it won't accept your
input.
It will still take several minutes to boot; haven't heard any reasons
for that yet. It stalls after "entry point at ...." for a few
minutes, then stalls again a couple of times. But it will finally
come up and appears to run ok after that.
--
Ron Oliver
