(Sorry, previous was with not correct my sender's email, please reply to [EMAIL PROTECTED])
Reading through misc archives I found this post http://marc.theaimsgroup.com/?l=openbsd-misc&m=112454454105020&w=2 Currently I got number of IBM ServeRAID 4M controllers (plus batteries packs) in couple with some IBM machines (eServer 6BY and some other models). It's dramatic for me because of "some ServeRaid cards are supported and some are not". And of course I have to to ask - is the ServeRAID 4M supported (some how)? When I tried to install 3.9 on it the installer ends with "no disk found"... But the card is at least recognized as (full dmesg below): "IBM ServeRAID" rev 0x00 at pci1 dev 7 function 0 not configured I want to know what does mean that message? Is the card MAY work (after some)? May be some BIOS, card BIOS or UKC options must be carefully set? I searched through /usr/src/sys/dev/pci/pcidevs and found some claws for "ServeRAID", but not found "ServeRAID" elsewhere... I tried to reproduce my searches with ami (MegaRAID - I added that card to that machine for experimental reasons) and I found some - man page, some claws in src. So where the definitions for ServeRAID? I respect developers anger about IBM behaviour... But if job for these controllers was already DONE and it might work somehow - so can I use it? OpenBSD 3.9-current (GENERIC.MP) #0: Sat May 20 14:35:00 YEKST 2006 [EMAIL PROTECTED]:/usr/src/sys/arch/i386/compile/GENERIC.MP cpu0: Intel Pentium III ("GenuineIntel" 686-class) 1 GHz cpu0: FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE real mem = 1073283072 (1048128K) avail mem = 971468800 (948700K) using 4256 buffers containing 53768192 bytes (52508K) of memory mainbus0 (root) bios0 at mainbus0: AT/286+(e2) BIOS, date 09/20/01, BIOS32 rev. 0 @ 0xfd2c1 pcibios0 at bios0: rev 2.1 @ 0xf0000/0xffff pcibios0: PCI BIOS has 11 Interrupt Routing table entries pcibios0: PCI Interrupt Router at 000:15:0 ("ServerWorks OSB4" rev 0x00) pcibios0: PCI bus #0 is the last bus bios0: ROM list: 0xc0000/0xa000 0xca000/0x1800 0xcb800/0x800 0xcc000/0x2200 0xce200/0x3400 mainbus0: Intel MP Specification (Version 1.4) (IBM GNK Teton SMP ) cpu0 at mainbus0: apid 1 (boot processor) cpu0: apic clock running at 132 MHz cpu1 at mainbus0: apid 0 (application processor) cpu1: Intel Pentium III ("GenuineIntel" 686-class) cpu1: FPU,CX8,APIC mainbus0: bus 0 is type PCI mainbus0: bus 1 is type PCI mainbus0: bus 2 is type PCI mainbus0: bus 3 is type PCI mainbus0: bus 4 is type PCI mainbus0: bus 5 is type ISA ioapic0 at mainbus0: apid 14 pa 0xfec00000, version 11, 16 pins ioapic1 at mainbus0: apid 15 pa 0xfec01000, version 11, 16 pins pci0 at mainbus0 bus 0: configuration mode 1 (no bios) pchb0 at pci0 dev 0 function 0 "ServerWorks CNB20LE Host" rev 0x05 pchb1 at pci0 dev 0 function 1 "ServerWorks CNB20LE Host" rev 0x05 pci1 at pchb1 bus 1 ahc0 at pci1 dev 3 function 0 "Adaptec AIC-7899 U160" rev 0x01: apic 15 int 12 (irq 11) scsibus0 at ahc0: 16 targets ahc1 at pci1 dev 3 function 1 "Adaptec AIC-7899 U160" rev 0x01: apic 15 int 13 (irq 11) scsibus1 at ahc1: 16 targets ami0 at pci1 dev 5 function 0 "Symbios Logic MegaRAID" rev 0x01: apic 15 int 4 (irq 10) ami0: LSI 520, 64b/lhc, FW 1L37, BIOS vG119, 64MB RAM ami0: 1 channels, 0 FC loops, 1 logical drives scsibus2 at ami0: 40 targets sd0 at scsibus2 targ 0 lun 0: <AMI, Host drive #00, > SCSI2 0/direct fixed sd0: 34712MB, 34712 cyl, 64 head, 32 sec, 512 bytes/sec, 71090176 sec total scsibus3 at ami0: 16 targets safte0 at scsibus3 targ 15 lun 0: <IBM, CaHv3 S2, 0> SCSI2 3/processor fixed "IBM ServeRAID" rev 0x00 at pci1 dev 7 function 0 not configured vga1 at pci0 dev 1 function 0 "S3 Savage 4" rev 0x04 wsdisplay0 at vga1 mux 1: console (80x25, vt100 emulation) wsdisplay0: screen 1-5 added (80x25, vt100 emulation) pcn0 at pci0 dev 2 function 0 "AMD 79c970 PCnet-PCI" rev 0x44, Am79c975, rev 4: apic 15 int 11 (irq 15), address 00:02:55:91:f 1:01 ukphy0 at pcn0 phy 30: Generic IEEE 802.3u media interface, rev. 0: OUI 0x00001a, model 0x0036 fxp0 at pci0 dev 9 function 0 "Intel 8255x" rev 0x08, i82559: apic 15 int 0 (irq 15), address 00:03:47:6a:10:f7 inphy0 at fxp0 phy 1: i82555 10/100 PHY, rev. 4 piixpm0 at pci0 dev 15 function 0 "ServerWorks OSB4" rev 0x4f: SMBus disabled pciide0 at pci0 dev 15 function 1 "ServerWorks OSB4 IDE" rev 0x00: DMA atapiscsi0 at pciide0 channel 0 drive 0 scsibus4 at atapiscsi0: 2 targets cd0 at scsibus4 targ 0 lun 0: <SAMSUNG, CD-ROM SC-148C, CI09> SCSI0 5/cdrom removable cd0(pciide0:0:0): using PIO mode 4, DMA mode 2, Ultra-DMA mode 2 ohci0 at pci0 dev 15 function 2 "ServerWorks OSB4/CSB5 USB" rev 0x04: apic 14 int 9 (irq 9), version 1.0, legacy support usb0 at ohci0: USB revision 1.0 uhub0 at usb0 uhub0: ServerWorks OHCI root hub, rev 1.00/1.00, addr 1 uhub0: 4 ports with 4 removable, self powered isa0 at mainbus0 isadma0 at isa0 pckbc0 at isa0 port 0x60/5 pckbd0 at pckbc0 (kbd slot) pckbc0: using irq 1 for kbd slot wskbd0 at pckbd0: console keyboard, using wsdisplay0 pmsi0 at pckbc0 (aux slot) pckbc0: using irq 12 for aux slot wsmouse0 at pmsi0 mux 0 pcppi0 at isa0 port 0x61 midi0 at pcppi0: <PC speaker> spkr0 at pcppi0 lpt0 at isa0 port 0x378/4 irq 7 npx0 at isa0 port 0xf0/16: using exception 16 pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo pccom1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo fdc0 at isa0 port 0x3f0/6 irq 6 drq 2 fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 18 sec biomask 0 netmask 0 ttymask 0 pctr: 686-class user-level performance counters enabled mtrr: Pentium Pro MTRR support dkcsum: sd0 matches BIOS drive 0x80 root on sd0a rootdev=0x400 rrootdev=0xd00 rawdev=0xd02 -- engineer
