Hello, recently, I „inherited“ one of Compulab‘s Fitlet3. I received it with Linux Mint installed and found all 4 available Ethernet ports working: 2 of its extensional FACET card and 2 of Intel‘s Elkhart Lake Atom X6425E with MARVELL-type PHY „88E1512" at Atom's PCIe bus (see link below).
Now, I tried a clean install of OpenBSD 7.3/AMD64 which smoothly worked out but only the FACET card Ethernet ports have been recognized properly. While assuming BIOS is ok since Linux Mint worked I am wondering how far the hardware combination of X6425E/MARVELL PHY 88E1512 is already set to be working or if there is some driver or other Kernel level code not available yet. After clean OpenBSD 7.3/AMD64 install I did afterboot, syspatch and sysmerge. Also, from Compulab‘s / FitPC‘s R&D folks (Andrey Mazlin) I was redirected to OpenBSD groups because they were not able to help. Here is, what they replied to my support request: "The best solution is to rise a question at OpenBSD kernel support community. We did try to ask them and what we've got: "I was able to created an OpenBSD custom kernel with this NIC enabled, but the device is still a pci-device not a network interface."" [end of citation]. At first, I have a short question: should first booting of OpenBSD 7.3/AMD64 have recognized mentioned hardware properly? If yes, I will follow-up at „sendbug“ with enclosed system info. Would appreciate any answer. Kind regards Wolfgang Link to Fitlet3 schematic: https://fit-pc.com/wiki/index.php?title=Fitlet3_Specifications_and_block_diagram
