> 2019-06-24 23:06 GMT+02:00, 3 <[email protected]>: >> i know that wifi adapters never worked in obsd(excluding those > I doubt that they never worked. Check this out: > https://man.openbsd.org/usb#Wireless_network_interfaces > You can find specific devices under each driver. For example I use an > Asus USB-N10 nano which works with the urtwn(4) driver
>> adapters for which drivers were written by vendors), but i found one >> that shows signs of life in 11n(11ac 2t2r supported by chip). it can >> be bought anywhere where there are samsung tv. moreover it even works >> in hostap mode(unlike the buggy athn). >> but without a ton of bugs not done: >> bwfm0: could not read register: TIMEOUT >> bwfm0: could not open rx pipe: IN_USE >> bwfm0: could not init bus >> bwfm0: firmware did not start up >> ..and sometimes kernel panic on boot, but works would still! >> meet https://wikidevi.com/wiki/Samsung_WCH730B >> bwfm0 at uhub0 port 1 configuration 1 interface 0 "Broadcom BCMUSB 802.11 >> Wireless Adapter" rev 2.10/0.01 addr 2 >> photo without cover: http://pichost.org/images/2019/06/24/Untitled-138.jpg >> it is shown where to solder the wires for wifi. on the right through >> two pins(ground is first) is bluetooth, but for obsd this does not >> matter(thx theo). >> data sheet for chip: https://www.cypress.com/file/310246/download >> >> first, urtwn doesn't support 11n. i have not checked but it is written there. second, hostap mode is not supported. third, the only one task that obsd can solve is to be a router. nothing more but even this task obsd can not solve adequately. and for this you need wifi support with hostap mode. if you have a device from the china there is usually a mini-pcie only with usb interface. for example https://aliexpress.com/item/Minisys-NUC-Celeron-J3160-4-4-Intel-i210AT-Nic-X86/32891699351.html only two drivers fit- athn and bwfm, but i could not get athn to work witn TL-WN821N(r3,r5)
