My ERL would not run SMP if coremask was 0x1 (ie, use only one cpu) so I setenv:ed the bootmask to add coremask=0x3 so that the bsd.mp would find both cores, otherwise it bombed while probing for the second.
2015-12-05 14:21 GMT+01:00 Daniel Ouellet <[email protected]>: > Not the end of the world, I was trying to see if I could boot OpenBSD on > this version of the EdgeRouter Pro from Ubiquiti. I try the latest > Octeon available just in case. > > I am still trying, but start to run out of idea and i do need to get > some sleep now. > > Anyone have a possible Idea as what I may try to load this may be. > > Look like the processor may not be configure here, or may be I don't > read it right: > > Anyway, this all from the start at the boot and then when it crash, it > retry to boot and then keep cycling in. > > I just wanted to give this a trill as the box is nice and have 8 Gb > ports, of witch 2 can also be SFP in a very small 1U may be 7 inch deep. > > Anyway, here it is. > > ============================== > > > Octeon ubnt_e200# resetJumping to start of image at address 0xbfca0000 > > > U-Boot 2012.04.01 (UBNT Build ID: 4670715-g7c4b1d0) (Build time: May 27 > 2014 - 11:19:05) > > Skipping PCIe port 0 BIST, in EP mode, can't tell if clocked. > Skipping PCIe port 1 BIST, reset not done. (port not configured) > BIST check passed. > UBNT_E200 r1:0, r2:15, serial #: 44D9E7410ECB > MPR 13-00317-15 > Core clock: 1000 MHz, IO clock: 600 MHz, DDR clock: 533 MHz (1066 Mhz DDR) > Base DRAM address used by u-boot: 0x8f800000, size: 0x800000 > DRAM: 2 GiB > Clearing DRAM...... done > Flash: 8 MiB > Net: octeth0, octeth1, octeth2, octeth3, octeth4, octeth5, octeth6, > octeth7 > MMC: Octeon MMC/SD0: 0 > USB: USB EHCI 1.00 > scanning bus for devices... 2 USB Device(s) found > Type the command 'usb start' to scan for USB storage devices. > > Hit any key to stop autoboot: 0 > (Re)start USB... > USB: USB EHCI 1.00 > scanning bus for devices... 2 USB Device(s) found > scanning bus for storage devices... 1 Storage Device(s) found > reading bsd.rd > > 7568951 bytes read > Allocating memory for ELF segment: addr: 0xffffffff81000000 (adjusted > to: 0x1000000), size 0x768c20 > ## Loading big-endian Linux kernel with entry point: 0xffffffff81000000 ... > Bootloader: Done loading app on coremask: 0x1 > Starting cores 0x1 > Total DRAM Size 0x0000000080000000 > Bank 0 = 0x000000000176C000 -> 0x000000000FFFFFFF > Bank 1 = 0x0000000410000000 -> 0x000000041FFFFFFF > Bank 2 = 0x0000000020000000 -> 0x000000007FFFC001 > mem_layout[0] page 0x00000000000005DB -> 0x0000000000003FFF > mem_layout[1] page 0x0000000000008000 -> 0x000000000001FFFF > mem_layout[2] page 0x0000000000104000 -> 0x0000000000107FFF > boot_desc->argv[1] = rootdev=/dev/sd0 > Initial setup done, switching console. > boot_desc->desc_ver:7 > boot_desc->desc_size:400 > boot_desc->stack_top:0 > boot_desc->heap_start:0 > boot_desc->heap_end:0 > boot_desc->argc:2 > boot_desc->flags:0x5 > boot_desc->core_mask:0x1 > boot_desc->dram_size:2048 > boot_desc->phy_mem_desc_addr:0 > boot_desc->debugger_flag_addr:0xc84 > boot_desc->eclock:1000000000 > boot_desc->boot_info_addr:0x1001f0 > boot_info->ver_major:1 > boot_info->ver_minor:3 > boot_info->stack_top:0 > boot_info->heap_start:0 > boot_info->heap_end:0 > boot_info->boot_desc_addr:0 > boot_info->exception_base_addr:0x1000 > boot_info->stack_size:0 > boot_info->flags:0x5 > boot_info->core_mask:0x1 > boot_info->dram_size:2048 > boot_info->phys_mem_desc_addr:0x48108 > boot_info->debugger_flags_addr:0 > boot_info->eclock:1000000000 > boot_info->dclock:533000000 > boot_info->board_type:20003 > boot_info->board_rev_major:0 > boot_info->board_rev_minor:15 > boot_info->mac_addr_count:8 > boot_info->cf_common_addr:0 > boot_info->cf_attr_addr:0 > boot_info->led_display_addr:0 > boot_info->dfaclock:0 > boot_info->config_flags:0x8 > Copyright (c) 1982, 1986, 1989, 1991, 1993 > The Regents of the University of California. All rights reserved. > Copyright (c) 1995-2015 OpenBSD. All rights reserved. > http://www.OpenBSD.org > > OpenBSD 5.8-current (RAMDISK) #1: Thu Nov 26 17:33:10 CET 2015 > [email protected]:/usr/src/sys/arch/octeon/compile/RAMDISK > real mem = 2122907648 (2024MB) > avail mem = 2106032128 (2008MB) > mainbus0 at root > cpu0 at mainbus0: Cavium OCTEON II CPU rev 0.1 1000 MHz, Software FP > emulation > cpu0: cache L1-I 512KB D 8KB 64 way, L2 1024KB 8 way > clock0 at mainbus0: int 5 > iobus0 at mainbus0 > dwctwo0 at iobus0 base 0x1180068000000 irq 56cn30xxgmx0 at iobus0 base > 0x1180008000000 irq 48 > unsupported octeon model: 0xd9301 > uar: ns16550, no working fifo > com0: console > com1 at uartbus0 base 0x1180000000c00 irq 35: ns16550, no working fifo > root on rd0a swap on rd0b dump on rd0b > WARNING: No TOD clock, believing file system. > WARNING: CHECK AND RESET THE DATE! > panic: pool_do_get: filepl free list modified: page 0x980000041e984000; > item addr 0x980000041e984000; offset 0x0=0x0 != 0xc45e62ccb6b162fe > syncing disks... done > System restart. > �Jumping to start of image at address 0xbfca0000 > > > U-Boot 2012.04.01 (UBNT Build ID: 4670715-g7c4b1d0) (Build time: May 27 > 2014 - 11:19:05) > > -- May the most significant bit of your life be positive.
