On Thu, 19 Jun 2014 10:30:15 +0200 (CEST), Mark Kettenis
<[email protected]> wrote:
> > jmphy0 at jme0 phy 1: JMP211 10/100/1000 PHY, rev.1
>
> What does ifconfig jme0 media print?
>
I've never reported before because I couldn't do enough test so I
thought it wouldn't be interesting but, as there's the thread:
I have a quite similar NIC than op:
$ dmesg |grep jme0
jme0 at pci2 dev 0 function 5 "JMicron JMC250" rev 0x03: apic 4 int 17,
address 80:ee:73:xx:xx:xx
jmphy0 at jme0 phy 1: JMP211 10/100/1000 PHY, rev. 1
The only difference is the "rev" he has 0x05 whereas I have 0x03.
I have two switchs, one 100Mbps and 1Gbps. If I plug it on the 100M it
works normally, if I try to plug it in the 1G, it simply won't detect
the cable (the led on the switch stays off) (I tried 4-wires and
8-wires eth cable, which I know they work on other NIC).
In my case:
media: Ethernet autoselect (100baseTX
full-duplex,rxpause,txpause)
status: active
supported media:
media 10baseT
media 10baseT mediaopt full-duplex
media 100baseTX
media 100baseTX mediaopt full-duplex
media 1000baseT
media 1000baseT mediaopt full-duplex
media autoselect
Maybe brad@ has another patch for jme? :p
Cheers,
--
Vigdis
