On 05/02/14 16:13, Stefan Sperling wrote: > OpenBSD doesn't support IPv6 autoconf on routers (i.e if forwarding > is enabled). Some ISPs have started using autoconf to assign a > global prefix for use on the WAN link. This violates early IPv6 RFCs > which said that a router cannot do autoconf. There is a newer RFC which > clears this up but OpenBSD doesn't support it yet: > http://tools.ietf.org/html/rfc6204 > > However, using a global prefix on your WAN link is usually not a > hard requirement since link-local addresses are sufficient for this. > > Try setting a default route that points to pppoe0: > > !/sbin/route add -inet6 default -ifp pppoe0 fe80:: > > Your router should now be able to reach the IPv6 internet. >
Thanks Stefan for the good explanation and the setting! I'll try it out in a bit. > Once this works you need to get your LAN connected, too. > Did you get a static IPv6 prefix from your ISP for your LAN? > Unfortunately it's all dynamic. M-Net used to be a friend about static IP addresses (which allowed me a tunnel to sixxs before), but they have turned against giving out static, whether v4 or v6. If I remember right they assign a /64 for the link, and give out a /48 somehow which is dynamic too. Regards, -peter
