apm has priority over acpi.

On Wed, Sep 18, 2013 at 18:32, Riccardo Mottola wrote:
> Hi,
> 
> checking ACPI on my older thinkpad T600x I notice (running current
> snapshot of today) I don't seem th have ACPI. I know that some older
> Thinkpads did have APCI "disabled by bios to avoid interfering with
> windows" (back then of course support was bad), so I read.
> 
> I read in dmesg (full dmesg below)
> 
> apm0 at bios0: Power Management spec V1.2
> acpi at bios0 function 0x0 not configured
> 
> I suppose that acpi is available but OpenBSD doesn't support my specific
> model?
> 
> (my previous laptop where I was developing some ACPI code broke, thus I
> put in the disk in this spare computer)
> 
> Riccardo
> 
> 
> OpenBSD 5.4-current (GENERIC) #54: Sat Sep 14 13:36:19 MDT 2013
> [email protected]:/usr/src/sys/arch/i386/compile/GENERIC
> cpu0: Intel Pentium III ("GenuineIntel" 686-class) 499 MHz
> cpu0:
> FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PSE36,PSN,MMX,FXSR,SSE
> 
> real mem  = 334884864 (319MB)
> avail mem = 317661184 (302MB)
> mainbus0 at root
> bios0 at mainbus0: AT/286+ BIOS, date 11/30/99, BIOS32 rev. 0 @ 0xfd820,
> SMBIOS rev. 2.2 @ 0xf7690 (55 entries)
> bios0: vendor IBM version "ITET55WW" date 11/30/1999
> bios0: IBM 26454EG
> apm0 at bios0: Power Management spec V1.2
> acpi at bios0 function 0x0 not configured
> pcibios0 at bios0: rev 2.1 @ 0xfd880/0x800
> pcibios0: PCI IRQ Routing Table rev 1.0 @ 0xf9d00/128 (6 entries)
> pcibios0: PCI Exclusive IRQs: 11
> pcibios0: PCI Interrupt Router at 000:07:0 ("Intel 82371AB PIIX4 ISA"
> rev 0x00)
> pcibios0: PCI bus #5 is the last bus
> bios0: ROM list: 0xc0000/0xc000
> cpu0 at mainbus0: (uniprocessor)
> pci0 at mainbus0 bus 0: configuration mode 1 (bios)
> pchb0 at pci0 dev 0 function 0 "Intel 82443BX AGP" rev 0x03
> intelagp0 at pchb0
> agp0 at intelagp0: aperture at 0x40000000, size 0x4000000
> ppb0 at pci0 dev 1 function 0 "Intel 82443BX AGP" rev 0x03
> pci1 at ppb0 bus 1
> vga1 at pci1 dev 0 function 0 "Neomagic Magicgraph NM2360" rev 0x00
> wsdisplay0 at vga1 mux 1: console (80x25, vt100 emulation)
> wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
> cbb0 at pci0 dev 2 function 0 "TI PCI1450 CardBus" rev 0x03: irq 11
> cbb1 at pci0 dev 2 function 1 "TI PCI1450 CardBus" rev 0x03: irq 11
> "AT&T/Lucent LTMODEM" rev 0x01 at pci0 dev 3 function 0 not configured
> clcs0 at pci0 dev 6 function 0 "Cirrus Logic CS4280/46xx CrystalClear"
> rev 0x01: irq 11
> ac97: codec id 0x43525913 (Cirrus Logic CS4297A rev 3)
> ac97: codec features headphone, 20 bit DAC, 18 bit ADC, Crystal Semi 3D
> piixpcib0 at pci0 dev 7 function 0 "Intel 82371AB PIIX4 ISA" rev 0x02:
> unable to claim ownership from BIOS, SpeedStep disabled
> pciide0 at pci0 dev 7 function 1 "Intel 82371AB IDE" rev 0x01: DMA,
> channel 0 wired to compatibility, channel 1 wired to compatibility
> wd0 at pciide0 channel 0 drive 0: <HTS421260H9AT00>
> wd0: 16-sector PIO, LBA48, 57231MB, 117210240 sectors
> wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2
> atapiscsi0 at pciide0 channel 1 drive 0
> scsibus0 at atapiscsi0: 2 targets
> cd0 at scsibus0 targ 0 lun 0: <TOSHIBA, DVD-ROM SD-C2302, 1617> ATAPI
> 5/cdrom removable
> cd0(pciide0:1:0): using PIO mode 4, DMA mode 2
> uhci0 at pci0 dev 7 function 2 "Intel 82371AB USB" rev 0x01: irq 11
> piixpm0 at pci0 dev 7 function 3 "Intel 82371AB Power" rev 0x03: SMI
> iic0 at piixpm0
> cardslot0 at cbb0 slot 0 flags 0
> cardbus0 at cardslot0: bus 2 device 0 cacheline 0x8, lattimer 0xb0
> pcmcia0 at cardslot0
> cardslot1 at cbb1 slot 1 flags 0
> cardbus1 at cardslot1: bus 5 device 0 cacheline 0x8, lattimer 0xb0
> pcmcia1 at cardslot1
> isa0 at piixpcib0
> isadma0 at isa0
> com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
> pckbc0 at isa0 port 0x60/5
> pckbd0 at pckbc0 (kbd slot)
> pckbc0: using irq 1 for kbd slot
> wskbd0 at pckbd0: console keyboard, using wsdisplay0
> pms0 at pckbc0 (aux slot)
> pckbc0: using irq 12 for aux slot
> wsmouse0 at pms0 mux 0
> pcppi0 at isa0 port 0x61
> spkr0 at pcppi0
> lpt2 at isa0 port 0x3bc/4: polled
> npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
> fdc0 at isa0 port 0x3f0/6 irq 6 drq 2
> usb0 at uhci0: USB revision 1.0
> uhub0 at usb0 "Intel UHCI root hub" rev 1.00/1.00 addr 1
> mtrr: Pentium Pro MTRR support, 8 var ranges, 88 fixed ranges
> vscsi0 at root
> scsibus1 at vscsi0: 256 targets
> softraid0 at root
> scsibus2 at softraid0: 256 targets
> ne3 at pcmcia0 function 0 "D-Link, DFE-670TXD, PC Card" port 0xa000/32,
> address 00:13:46:34:0d:62
> nsphyter0 at ne3 phy 1: DP83815 10/100 PHY, rev. 0
> root on wd0a (378dd2c6192ddec8.a) swap on wd0b dump on wd0b
> clcs0: firmware loaded
> audio0 at clcs0
> wd0(pciide0:0:0): timeout
> type: ata
> c_bcount: 4096
> c_skip: 0
> wd0a: device timeout writing fsbn 6592 of 6592-6599 (wd0 bn 6655; cn 6
> tn 9 sn 40), retrying
> wd0: soft error (corrected)
> ne3: device timeout
> ne3: device timeout
> ne3: device timeout
> ne3: device timeout

Reply via email to