On 07/07/2011 10:43 PM, Jeremiah Foster wrote:
On 07/07/2011 03:24 PM, bradleyyan wrote:
I downloaded the meego repo to local machine,using the local repo to
install packages.
And when install image in machine using GUI mode,it said:
"X startup failed"
"/usr/sbin/liveinst: line93: kill: `': not a pid or valid job spec"
Problem had been solved,
How was it solved?
First,the oaktrail platform need special packages to support X.I did not
installed all needed packages to support X for oaktrail.
So the X can't start when using graphical mode to install.(But I had
installed all needed packages,the graphical installation failed at the
end also,so I used text mode.)
Second,installer and installer-shell packages is needed for installation.
Third, if your meego imge is usbimage,you must run the follwing
steps(tom z said):
1) make sure syslinux exists in your host and its version is not
equal to 4.00(v4.02 is the best)
2) sudo losetup -o 512 /dev/loop* XXX.usbimg (loop* is a available
one)
3) sudo syslinux -d syslinux /dev/loop*
4) sudo losetup -d /dev/loop*
Fourth,If you use local repo to install packges,you need to create the
repodata.
the meego img doesn't support GUI mode
installation.
Is that correct for all images built with mic-image-creator? You
cannot install in graphical mode?
I am not sure about all images built with mic-image-creator,the image
created by me can not support graphical mode installation.
So I used text mode to install system.
Otherwise,I used meego official image to install using graphical mode
in oaktrail platform,when execting copying image to disk step,the X
failed,error codes is as follows:
/usr/sbin/liveinit line 80: 708 Aborted $ANACONDA $* 2> /dev/null
THanks.
Bradley Yan
_______________________________________________
MeeGo-dev mailing list
[email protected]
http://lists.meego.com/listinfo/meego-dev
http://wiki.meego.com/Mailing_list_guidelines
