Dear list, I'm using hotlink in MI 6.0 to display only selected registered ortofotos in a grid. The hotlink points to the *.tab files. Everything works just fine on my pc, but when I try to use hotlink on other computers in the network, they start a new session (open MI again) and display only the registered foto. I'm not sure if this is relevant, but the fotos and *.tab files are stored on my harddrive as a shared folder, (which is a mapped network drive on the client computers.) ANY suggestions - I'm out of ideas.... Does anybody know if it is possible to store more than one hotlink in the same table? venlig hilsen S�ren Breddam _______________________________________________________________________ List hosting provided by Directions Magazine | www.directionsmag.com | To unsubscribe, send e-mail to [EMAIL PROTECTED] and put "unsubscribe MapInfo-L" in the message body.
