Afternoon All (depends on your spatial location obviously)
I've just done a split operation in MI 4.5.2 but some of the lines have
remained 'joined.' that is they are the polyline equivalent of complex
regions (where you have multiple polys for one record in the attribute
table). i need to split these up completely as i have to have one line in
the table for each spatial object. i could port the whole lot into ArcInfo
(PC version via e00) and then back again which would sort it but it seem
like a load of hassle
any ideas ?
TIA and will sum (damn i haven't done the last one - expect it about 5.00pm
when i am really desperate to go home).
Jon.
Jonathan Stokes
GIS Analyst
*******************************************************
Geoplan, 14 - 15 Regent Parade, Harrogate,
North Yorkshire, HG1 5AW.
tel 00 44 (0) 1423 722715
fax 00 44 (0) 1423 525 545
www.geoplan.com
*******************************************************
----------------------------------------------------------------------
To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put
"unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED]
