Check out the Machinetalk wrapper. It has this functionality built in for
remote UIs.
John
________________________________________
From: [email protected] <[email protected]> on behalf of
Michael Labuda <[email protected]>
Sent: Tuesday, June 16, 2020 11:33 PM
To: Machinekit
Subject: [Machinekit] Sending gcode to Machinekit from remote source
Greetings fellow Machinekit users,
I am wondering if Machinekit has any method of remotely receiving gcode
commands from another application, similar to MDI mode except code is not typed
directly at the UI. I am not concerned about security or latency and the gcode
instructions I intend to send over are very simple, just G00/G01 and an
occasional M code. I have found some unresolved posts asking a similar question
however they are all several years old. Has such a capability been added on
since then? Could someone point me in the best direction in which to implement
such an option? I am open to developing a solution myself is necessary. Any
advice would be greatly appreciated.
Thanks,
Michael
--
website: http://www.machinekit.io blog: http://blog.machinekit.io github:
https://github.com/machinekit
---
You received this message because you are subscribed to the Google Groups
"Machinekit" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to
[email protected]<mailto:[email protected]>.
To view this discussion on the web visit
https://groups.google.com/d/msgid/machinekit/0a67eaea-755a-4cb1-87c9-d82789169d06o%40googlegroups.com<https://groups.google.com/d/msgid/machinekit/0a67eaea-755a-4cb1-87c9-d82789169d06o%40googlegroups.com?utm_medium=email&utm_source=footer>.
--
website: http://www.machinekit.io blog: http://blog.machinekit.io github:
https://github.com/machinekit
---
You received this message because you are subscribed to the Google Groups
"Machinekit" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To view this discussion on the web visit
https://groups.google.com/d/msgid/machinekit/BYAPR12MB3589286E8DA6CBAD130DEAC4859A0%40BYAPR12MB3589.namprd12.prod.outlook.com.
