Hi, Apr 4, 2020, 04:04 by [email protected]: > > > I did the same when I did mine....had a lapse along the way and screwed up > the signal to pin mapping. As long as the daughter boards match the cape no > probs. In my defense I was looking after a Beagle pup we got at 8 weeks old. > > There's also the raw pins brought out for the ADC, an I2C bus and for an > external power switch. > > I don't know if you've seen my spread sheet but I've thrown it up (hopefully > without any major typos). With a bit more thought some pins would have been > better elsewhere, but I was aiming at a simple conversion from a 2 port PP > setup. Hence the "output daughter board" resembling a Std PP and the Input > resembling a PP setup for input. > > I figured that the main cape could be used on it's own for experimenting with > external devices without the daughter board. > > But I'd be interested to see your progression, as I have time on my hands now > as I stopped the Linuxcnc Mint ISO's, the devs prefer seem just to support > Debian. > the great thing about open-source is that you don't have to care about preferences of some arbitrary "dev". You can do whatever you want as long as it is fun for you (or you get something else out of it).
(I just hate for interested users to lose their enthusiasm.) Cern. > > So you want someone to bounce ideas off my old noggin is pretty hard & dense. > > Cheers > Rob > > > > > > > > -- > website: > http://www.machinekit.io> blog: > http://blog.machinekit.io> > github: > https://github.com/machinekit > --- > You received this message because you are subscribed to the Google Groups > "Machinekit" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to > [email protected]> . > To view this discussion on the web visit > > https://groups.google.com/d/msgid/machinekit/2bfd00d0-0278-4eb4-b8ab-484205f74260%40googlegroups.com > > <https://groups.google.com/d/msgid/machinekit/2bfd00d0-0278-4eb4-b8ab-484205f74260%40googlegroups.com?utm_medium=email&utm_source=footer>> > . > -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/machinekit/M44Rfow--7-2%40tuta.io.
