What i want to do is to make cnc lathe with servo motor spindle using step/dir. But i just didnt find any config for lathe
2018 m. lapkritis 7 d., trečiadienis 12:58:41 UTC+2, Schooner rašė: > > As Bas said, you need to modify an existing BBB config. > > There are a whole layer of reasons why what you did will not work. > Right at the top, is that you don't have a parport (parallel port). > > The main reason people use the BBB, is that Charles programmed the PRU for > hardware stepping etc. > thus breaking the vicious circle of using the parport and the ultra low > latency kernel requirement that exists in linuxcnc, > for basic hardware. > > On 07/11/18 10:40, Bas de Bruijn wrote: > > Hi, > > Stepconf does not work for making a configuration for the Beaglebone. > It’s easier to take an existing configuration for a Beaglebone setup and > modify for your situation. > > Bas > > On 7 Nov 2018, at 11:36, Gediminas Dirma <[email protected] > <javascript:>> wrote: > > Hello > > I am new to machinekit and i have some problems with stepconfig. After i > setup my configuration for lathe and i start it, it doesnt work. Then i > read why it stopped it says because my_lathe.hal and the line is 'setp > parport.0.reset-time 5000'. Than i comment this line i can launch my > config. So what does this line mean, can i leave it commented or maybe i > should change something. > > Thanks for help. > -- > website: http://www.machinekit.io blog: http://blog.machinekit.io github: > https://github.com/machinekit > --- > You received this message because you are subscribed to the Google Groups > "Machinekit" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected] <javascript:>. > Visit this group at https://groups.google.com/group/machinekit. > For more options, visit https://groups.google.com/d/optout. > > -- > website: http://www.machinekit.io blog: http://blog.machinekit.io github: > https://github.com/machinekit > --- > You received this message because you are subscribed to the Google Groups > "Machinekit" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected] <javascript:>. > Visit this group at https://groups.google.com/group/machinekit. > For more options, visit https://groups.google.com/d/optout. > > > -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.
