On 02/01/2017 10:46 AM, Tom M wrote:
Thank for the quick response.
When we connected charge pump we got a nice 500 Hz signal albeit 3
volts. When I attempted to create a 10k thread this is what we got as
far as a trace.
3 Volts isn't high enough. The current into the G540 won't start to flow
until you get above 3 Volts. Once you get flow, you need to make sure
you get enough current. The input is DC blocked so you need to ensure
there is enough high and low time to get good AC. The frequency isn't
that important -- 200 Hz to 2 kHz should be okay.
--
Kirk Wallace
http://www.wallacecompany.com/machine_shop/
http://www.wallacecompany.com/E45/
--
website: http://www.machinekit.io blog: http://blog.machinekit.io github:
https://github.com/machinekit
---
You received this message because you are subscribed to the Google Groups "Machinekit" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
Visit this group at https://groups.google.com/group/machinekit.
For more options, visit https://groups.google.com/d/optout.
