--- Begin Message ---
> So, I have three possible solutions, in order:
> 1/ Can you modify your server to include the “source=“ parameter in the
> “SETUP” response (because it is choosing to send the stream from a different
> IP address)?
> 2/ If not, can you not do this redirection at all?
> 3/ If neither is the case, then unfortunately the only way I can see to get
> the IP source address of each RTP packet is to modify the LIVE555 library
> code. Specifically, you could modify the
> "MultiFramedRTPSource::networkReadHandler1()” function (at line 248 of
> “MultiFramedRTPSource.cpp”) to use “fromAddress”. But because you would be
> modifying the LIVE555 code, you’re on your own here.
I'll have to experiment with these, thank you! I'm inclined to agree with you
that the specification should have been a "MUST" :)
Best,
Eric Liu
On 5/30/23, 7:13 PM, "live-devel on behalf of Ross Finlayson"
<live-devel-boun...@us.live555.com <mailto:live-devel-boun...@us.live555.com>
on behalf of finlay...@live555.com <mailto:finlay...@live555.com>> wrote:
> On May 30, 2023, at 6:13 PM, Liu, Eric via live-devel
> <live-de...@us.live555.com <mailto:live-de...@us.live555.com>> wrote:
>
> Since I don't see any "Source" or "source=" fields in any of the SETUP
> responses, would it be accurate to say that in this case the server is not
> replying with the "source=" parameter properly and we are not able to get the
> IP address through this method (with this server)?
Unfortunately, that’s correct. Looking at RFC 2326 (the specification for
RTSP), in section 12.39, I see:
"source:
If the source address for the stream is different than can be
derived from the RTSP endpoint address (the server in playback
or the client in recording), the source MAY be specified."
So yes, the “source” parameter is optional, even if - as in your case - the RTP
packets’ source address is different from that of the server. I would argue
that this “MAY” in the specification should have been a “MUST”.
So, I have three possible solutions, in order:
1/ Can you modify your server to include the “source=“ parameter in the “SETUP”
response (because it is choosing to send the stream from a different IP
address)?
2/ If not, can you not do this redirection at all?
3/ If neither is the case, then unfortunately the only way I can see to get the
IP source address of each RTP packet is to modify the LIVE555 library code.
Specifically, you could modify the
"MultiFramedRTPSource::networkReadHandler1()” function (at line 248 of
“MultiFramedRTPSource.cpp”) to use “fromAddress”. But because you would be
modifying the LIVE555 code, you’re on your own here.
Ross Finlayson
Live Networks, Inc.
http://www.live555.com/ <http://www.live555.com/>
_______________________________________________
live-devel mailing list
live-devel@lists.live555.com <mailto:live-devel@lists.live555.com>
http://lists.live555.com/mailman/listinfo/live-devel
<http://lists.live555.com/mailman/listinfo/live-devel>
--- End Message ---
_______________________________________________
live-devel mailing list
live-devel@lists.live555.com
http://lists.live555.com/mailman/listinfo/live-devel