Hi Rob,
Thanks for your review. Please see below.
On 7/7/20, 3:41 AM, "Robert Wilton via Datatracker" <[email protected]> wrote:
Robert Wilton has entered the following ballot position for
draft-ietf-lisp-gpe-16: No Objection
When responding, please keep the subject line intact and reply to all
email addresses included in the To and CC lines. (Feel free to cut this
introductory paragraph, however.)
Please refer to https://www.ietf.org/iesg/statement/discuss-criteria.html
for more information about IESG DISCUSS and COMMENT positions.
The document, along with other ballot positions, can be found here:
https://datatracker.ietf.org/doc/draft-ietf-lisp-gpe/
----------------------------------------------------------------------
COMMENT:
----------------------------------------------------------------------
Hi,
I found this document easy to read and understand.
A couple of minor comments:
4.3. UDP Checksum
By default, UDP checksum MUST be used when LISP-GPE is transported
over IPv6. A tunnel endpoint MAY be configured for use with zero UDP
checksum if additional requirements in Section 4.3.1 are met.
This paragraph could probably be moved/merged into section 4.3.1?
[FM] good catch. We have moved it there in rev-17
4.4. DSCP, ECN and TTL
When a LISP-GPE router performs Ethernet encapsulation, the inner
header 802.1Q [IEEE.802.1Q_2014] VLAN Identifier (VID) MAY be mapped
to, or used to determine the LISP Instance IDentifier (IID) field.
This text doesn't appear to be related to DSCP, ECN or TTL. Perhaps tweak
the
title of this section to cover this text?
[FM] Good point. Changed to " DSCP, ECN, TTL, and 802.1Q".
Thanks,
Fabio
Regards,
Rob
_______________________________________________
lisp mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/lisp
