Hello.
[EMAIL PROTECTED] wrote:
> when i am booting montavista kernel using uboot i couldn't get any message
> on Console...
> i can view the booting messages by "Dumping the printk Log Buffer". i am
> passing the "bootargs=console=ttyS0,115200 root=/dev/ram0 rw"...is that i
I suspect you should use ttyCPM0 instead of ttyS0. Thi board very likely
has CPM2, so its UARTs are the only ones that exist.
> have to make any modification in kernel configuration to support
> appropriate serial port for display boot messags.. find the attached printk
You should enable CONFIG_SERIAL_CPM (if it's not already enabled).
> buffer screen shot? can anybody help?
You have actually replied only to me, not the maillist
> Regards,
> Saravanan.S
WBR, Sergei
_______________________________________________
Linuxppc-embedded mailing list
[email protected]
https://ozlabs.org/mailman/listinfo/linuxppc-embedded
