Hi all,
First off big thanks to the guys working on the Cypress USB C67X00 driver!
Without them I would not even be this far.
But my question for them is: How are you guys initializing the Cypress chip?
It looks like the driver is expecting the cypress to be programmed and ready.
I have a FPGA design with a Cypress C67300 which has no eeprom or cpld, so it
just comes up blank in coprocessor mode.
I believe I need to 'program' the chip and kick it before the driver loads is
that right?
Has anyone ever done this before?
The Cypress docs do not even begin to provide a simple example of the minimum
registers to set
before the usb will 'work'. I just need 2 hosts.
Thanks,
Joe Robertson
x8259
[EMAIL PROTECTED]
CONFIDENTIALITY
This e-mail message and any attachments thereto, is intended only for use by
the addressee(s) named herein and may contain legally privileged and/or
confidential information. If you are not the intended recipient of this e-mail
message, you are hereby notified that any dissemination, distribution or
copying of this e-mail message, and any attachments thereto, is strictly
prohibited. If you have received this e-mail message in error, please
immediately notify the sender and permanently delete the original and any
copies of this email and any prints thereof.
ABSENT AN EXPRESS STATEMENT TO THE CONTRARY HEREINABOVE, THIS E-MAIL IS NOT
INTENDED AS A SUBSTITUTE FOR A WRITING. Notwithstanding the Uniform Electronic
Transactions Act or the applicability of any other law of similar substance and
effect, absent an express statement to the contrary hereinabove, this e-mail
message its contents, and any attachments hereto are not intended to represent
an offer or acceptance to enter into a contract and are not otherwise intended
to bind the sender, Sanmina-SCI Corporation (or any of its subsidiaries), or
any other person or entity.
_______________________________________________
Linuxppc-embedded mailing list
[email protected]
https://ozlabs.org/mailman/listinfo/linuxppc-embedded
