Wish I could help ... I have been mostly using a mvista source tree though...
And I have never tried to switch kernel versions yet ;-) Jim -----Original Message----- From: Xiaogeng (Shawn) Jin [mailto:[EMAIL PROTECTED] Sent: Tuesday, January 14, 2003 12:59 PM To: James Don Cc: 'linuxppc-embedded at lists.linuxppc.org' Subject: Re: Configure 8xx_io in 2.4.21-pre3 Hi Jim, Thank you for your suggestions. I had a working 2.4.4 (released by DENX) kernel on my board, which has more stuff related to 8xx_io than 2.4.21-pre3. I don't know if those DENX-added stuff are necessary to enable 8xx CPM or if the 8xx_io code in 2.4.21 is sufficient to make 8xx CPM working. Probably I need to compare the code in these two versions line by line. - Shawn. > 1.) I recommend start with UART only build of the kernel first > > 2.) Did you check that your PA,PB,PC, and PD pins are set up properly ... > > I my custom board had pins moved for things like enet on SCC ? However > normally I believe SMC1 only can be on one pair of pins for a UART ... > another > > 3.) Another thing to look at is your BRG clock for your board ... in my > kernel I found mvista didn't look at the some parts of the hardware reset > word that divide down my 80 Mhz reference intenerally before it goes to the > brg ... I was really surprised this code wasn't there ... ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
