<insert favorite curses here> Spend 6 hours searching, draft an email to the list, and solve problem 20 minutes later. Compared my BDI to a co-workers and and discovered that although we had the same firmware, we didn't have the same "Logic" version in the device. Reflashed and I can now read the PVR correctly.
Sorry to waste everyone's time on this. Andrew > -----Original Message----- > From: linuxppc-embedded-bounces at ozlabs.org > [mailto:linuxppc-embedded-bounces at ozlabs.org] On Behalf Of > Williams, Andrew [CAR:9D30:EXCH] > Sent: August 25, 2005 10:38 AM > To: linuxppc-embedded at ozlabs.org > Subject: COP Status 0x21 > > > Hello List.. > (hope this is considered "on" topic) > > Situation: New hardware (mcp8347) > BDI connected, but unable to read PVR > Prior to the READ I see a "COP status is 0x21" > > Q. What does a status of 0x21 mean? > > Q. I've searched online for some type of a reference to the > COP interface to no avail. Can anyone direct me to > a technical reference? > > > Thanks, > Andrew > > -- BDI Config [TARGET] section -- > [TARGET] > CPUTYPE 8349 ;the CPU type > JTAGCLOCK 0 ;use 16 MHz JTAG clock > BOOTADDR 0xfff00100 ;boot address used > for start-up > break > POWERUP 2000 ;start delay after power-up > detected in ms > WAKEUP 800 ;give reset time to complete > STARTUP RESET ;halt immediatelly at the boot > vector > BREAKMODE HARD ;SOFT or HARD, HARD uses PPC > hardware breakpoint > STEPMODE HWBP ;TRACE or HWBP, HWBP uses a > hardware breakpoint > > > -- BDI Debug Output -- > - TARGET: waiting for target Vcc > - TARGET: processing power-up delay > - TARGET: processing user reset request > - BDI asserts HRESET > - Reset JTAG controller passed > - Bypass check: 0x00000001 => 0x00000001 > - Bypass check: 0x00000001 => 0x00000001 > - JTAG exists check passed > - COP status is 0x21 > - Check running state passed > - BDI scans COP freeze command > - BDI removes HRESET > - Target PVR is 0x00000000 > - This PVR is not supported > - TARGET: Target PVR is 0x00000000 > *** TARGET: resetting target failed > # PPC: This target is not supported > - TARGET: target will be restarted in 10 sec > _______________________________________________ > Linuxppc-embedded mailing list > Linuxppc-embedded at ozlabs.org > https://ozlabs.org/mailman/listinfo/linuxppc-> embedded > >
