We are using a custom 8260 board (which is based on est8260) where we have configured the SCC1 as 10Mbit Ethernet (eth0), FCC1 (eth1) and FCC2 (eth2) as Fast Ethernet.
We are using the PPcboot 1.2.0 on eth0 together with the ELDK. When we configure only SCC1 and FCC2 it's all OK, and the two interfaces have different MAC addresses, when we try to use both FCC1 and FCC2 (or FCC1 only) together with SCC1 we are able to configure the eth1 and eth2 I/Fs but we do not have any ping out from them. Moreover we have noted that eth0 and eth1 (when is on FCC1) have the same MAC address. Any suggestions? Many thanks Gianfranco ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
