On Tue, 2007-06-26 at 12:02 -0400, Stephen Winiecki wrote: > > I'm using the Denx linux-2.6-denx.git repository with a Katmai board. I > > want to boot off a disk (initialized w/ Debian 4.0). I've installed a > > Promise Ultra133 Tx2 IDE controller card in the PCI slot, and configured > > > it in the kernel. I boot this same disk w/ IDE card on other 4xx > boards > > without a problem (Bamboo w/ Denx 4.1 for example). I am getting an > error > > "init has generated signal 4 but has no handler for it". > > I believe the problem may be due to lack of HW FP on the processor(?). > Copying an embedded 440 RFS on disk works OK.
Signal 4 is SIGILL, which could be returned for float instructions I suppose. Try turning on CONFIG_MATH_EMULATION in your kernel config for Katmai and see if the problem goes away. josh _______________________________________________ Linuxppc-embedded mailing list [email protected] https://ozlabs.org/mailman/listinfo/linuxppc-embedded
