No, i didn't do the burst memory test, how do i do it then ?
On 11/17/06, Dave Liu <[EMAIL PROTECTED]> wrote: > On Thu, 2006-11-16 at 10:44 -0500, Lei Sun wrote: > > Hi all: > > I am trying to bring up customized board based on MPC8270, the > > kernel version is 2.4.30, it works fine on one of the Eval board > > (PQ2FADS-VR, which use MPC8275). > > The kernel hangs after uncompressing is done, further debug shows > > that it hangs right after "rfi " instruction of the turn_on_mmu: > > function in head.S > > > > turn_on_mmu: > > 240 mfmsr r0 > > 241 ori r0,r0,MSR_DR|MSR_IR > > 242 mtspr SRR1,r0 > > 243 lis r0,[EMAIL PROTECTED] > > 244 ori r0,r0,[EMAIL PROTECTED] > > 245 mtspr SRR0,r0 > > 246 SYNC > > 247 RFI /* enables MMU */ > > > > After i step over the RFI instruction, the PC points to C000XXX , but > > all memory content is 0 by then. > > my BATU0 is 0xC000FFE0 BATL0 is 0x00000002, I have 128MB RAM. The > > u-boot works fine, without MMU turned on. We do have some hardware > > problem, such that i have to lower the bus frequency to make the SDRAM > > stable. What physical parameter could cause the board not working with > > MMU on? > > When MMU turn on, the kernel memory should be cacheable, so the > processor will burst read instructions from memory to i-cache. Did you > do the burst read/write memory test in u-boot? As you said, you did not > do the test. > > -Dave > > > _______________________________________________ Linuxppc-embedded mailing list [email protected] https://ozlabs.org/mailman/listinfo/linuxppc-embedded
