i've tryed to install u-boot using minicom, but i'm not able to configure in shell boot params, using this...
boot device : motfcc unit number : 0 processor number : 0 host name : motfcc0 inet on ethernet (e) : 192.168.0.4 inet on backplane (b): 192.168.0.4 host inet (h) : 192.168.0.3 gateway inet (g) : 192.168.0.3 flags (f) : 0x80 target name (tn) : sbc8260 when i reboot target it appears in minicom the message below: AT S7=45 S0=0 L1 V1 X4 &c1 E1 Q0 0x1f058b0 (tBoot): miiPhyInit check cable connection Attached TCP/IP interface to motfcc0. Warning: no netmask specified. Attaching network interface lo0... done. Loading... Erroneous header read Error loading file: errno = 0x610001. Can't load boot file!! ΓΌ my questions are? what file must i put into target?(u-boot.bin?) in which way can i upload it?(using tftp with 192.168.0.4 and using put command, it gives timeout for transmission, but ping to 192.168.0.3 works normally until in minicom appears error message) Please help me to configure and install u-boot thanks very much!!! Naviga e telefona senza limiti con Tiscali Scopri le promozioni Tiscali adsl: navighi e telefoni senza canone Telecom http://abbonati.tiscali.it/adsl/ _______________________________________________ Linuxppc-embedded mailing list [email protected] https://ozlabs.org/mailman/listinfo/linuxppc-embedded
