AMD8111: IDE controller at PCI slot 01:04.1
AMD8111: chipset revision 3
AMD8111: not 100% native mode: will probe irqs later
AMD8111: neither IDE port enabled (BIOS)
So you need to add two lines in the MB Config.lb
device pci 1.6 off end
+ register "ide0_enable" = "1"
+ register "ide1_enable" = "1"
Ron/Stefan,
Current who maintain AMD MB support?
YH
> -----Original Message-----
> From: Nathanael Noblet [mailto:[EMAIL PROTECTED]
> Sent: Friday, April 22, 2005 11:36 AM
> To: beneo
> Cc: LinuxBIOS
> Subject: Re: Booting Linux using netboot and HD
>
>
> On Apr 22, 2005, at 11:05 AM, beneo wrote:
>
> > Below is the dump from Console, starting from LinuxBIOS to Kenel
> > Panic, If you see anything strange, please let me know.
>
> It seems good to me. Here is where my lack of knowledge tells
> me to stick with what I know. I don't know how the initrd is
> loaded via etherboot. Which to me seems to be the problem. I
> would hazard a guess that if you were to switch payloads to
> FILO, and it compiled and replaced etherboot without a
> problem you would be good to go. Though since you have
> etherboot working. Compiling a kernel and building into it
> the modules needed to mount the partitions you'd have success
> just as fast as you can compile...
>
> --
> Nathanael D. Noblet
> Gnat Solutions
> 204 - 131 Gorge Road E
> Victoria, BC V9A 1L1
>
> T 250.385.4613
> C 250.893.4613
> http://www.gnat.ca/
>
> _______________________________________________
> Linuxbios mailing list
> [email protected]
> http://www.clustermatic.org/mailman/listinfo/linuxbios
>
_______________________________________________
Linuxbios mailing list
[email protected]
http://www.clustermatic.org/mailman/listinfo/linuxbios
