Hi Luc,
Can you check that you have the following lines in
mainboard/via/epia/Options.lb
use CONFIG_CONSOLE_SERIAL8250
default CONFIG_CONSOLE_SERIAL8250=1
I had a similar problem until I added these.
You should see LB getting a little further.
Regards
Mark Wilkinson
Quoting Luc Belliveau <[EMAIL PROTECTED]>:
I compiled from freebios2 from cvs, when I boot all I get back from the
serial port is:
LinuxBIOS-1.1.7.0Normal <date> starting..
vt8601 init starting
Slot 00 is SDRAM 04000000 bytes x2
Slot 01 is empty
Slot 02 is empty
Slot 03 is empty
vt8601 is done
that's it. I tried changing the DEFAULT_CONSOLE_LOGLEVEL but when I do
that the resulting rom stops at Slot 00 is SDRAM 04000000 bytes x2.
I can't add uses DEFAULT_CONSOLE_LOGLEVEL or option
DEFAULT_CONSOLE_LOGLEVEL in the Config.lb file either, the buildtarget
scripts shuns it.
I'm using FILO as the payload, with no vga bios yet.
Could it be a FILO problem? I've never seen linuxBIOS before yesterday
so I don't know what should be appearing on the terminal..
Any assistance would be appreciated :)
Luc
_______________________________________________
Linuxbios mailing list
[EMAIL PROTECTED]
http://www.clustermatic.org/mailman/listinfo/linuxbios
----------------------------------------------------------------
This message was sent using ISPMailNow.com
_______________________________________________
Linuxbios mailing list
[EMAIL PROTECTED]
http://www.clustermatic.org/mailman/listinfo/linuxbios
