Stefan Reinauer <[EMAIL PROTECTED]> writes: > Hi there, > > the error disclosure of the config tool is a little bit mystic. > Building the sandpoint configuration says the following:
> This looks like an error in the config tool, while it is a mistake in the > config file. Is there any easy way to point the user/developer to the > place in the config file that is wrong (rather than printing a python > traceback)? This could make it a lot easier for newbies to create fresh > linuxbios ports to motherboards whose hardware is basically already > supported and it could safe the regulars quite some time comparing > config files between the ports... Last I looked a lot of the problem is design issues with the python parser generator the code is using. It does not do a very good job at remember making it possible to print good error messages. The case you mention does not look like the typical failure there so it may allow for a simple fix. Eric _______________________________________________ Linuxbios mailing list [EMAIL PROTECTED] http://www.clustermatic.org/mailman/listinfo/linuxbios
