Sorry it is function 0. -----邮件原件----- 发件人: Li-Ta Lo [mailto:[EMAIL PROTECTED] 发送时间: 2004年3月24日 9:39 收件人: YhLu 抄送: [EMAIL PROTECTED]; Stefan Reinauer; ron minnich; LinuxBIOS 主题: re: S4882 support
On Wed, 2004-03-24 at 10:43, YhLu wrote: > Eric, > > After check 84/a4/c4, 88/a8/c8 of function 1 of K8 northbridge, the link > speed/width is not init properly. > Is it function 0 ? Ollie > Regards > > YH > > -----邮件原件----- > 发件人: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] > 发送时间: 2004年3月23日 23:42 > 收件人: YhLu > 抄送: Stefan Reinauer; ron minnich; [EMAIL PROTECTED] > 主题: Re: S4882 support > > YhLu <[EMAIL PROTECTED]> writes: > > > Eric, > > > > The ht reset in auto.c seems not thoroughly. > > > > And it will stuck at hard_reset in amdk8_scan_chains. ( at this time can > not > > access 8111 yet). > > Correct. The early hypertransport initialization code is not > complete in the 4P case. That incompleteness triggers the later > fixups. > > I could not test that case, and there were at least some small > difficulties in that it was not obvious how the 4P case should > be extended to work properly. > > Why you are getting stuck in amdk8_scan_chains I do not currently > understand yet. I suspect Stefan's suggestion of a delayed reset > is the appropriate course to implement. > > Eric > _______________________________________________ > Linuxbios mailing list > [EMAIL PROTECTED] > http://www.clustermatic.org/mailman/listinfo/linuxbios > _______________________________________________ Linuxbios mailing list [EMAIL PROTECTED] http://www.clustermatic.org/mailman/listinfo/linuxbios
