I have been following these instructions:
https://linux-sunxi.org/Allwinner_Nezha#Mainline_kernel
But u-boot does not accept my kernel image.
I tried both Image.gz and Image
=> ext4load mmc 0:1 ${kernel_addr_r} Image
20515704 bytes read in 1906 ms (10.3 MiB/s)
=> bootm ${kernel_addr_r}
Wrong Image Format for bootm command
ERROR: can't get kernel image!
The load command works fine. But when trying to boot it from memory, the
format is not accepted?
The image was built with:
$ make ARCH=riscv CROSS_COMPILE=riscv64-linux-gnu-
...
OBJCOPY arch/riscv/boot/Image
GZIP arch/riscv/boot/Image.gz
Kernel: arch/riscv/boot/Image.gz is ready
The host PC just identifies it as 'data' though:
$ file Image
Image: data
--
You received this message because you are subscribed to the Google Groups
"linux-sunxi" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To view this discussion on the web, visit
https://groups.google.com/d/msgid/linux-sunxi/f2bbd5cb-5eac-4718-9491-3e059f38d448n%40googlegroups.com.
