Hello,
This is the v2 of the older patches from:
http://lists.infradead.org/pipermail/linux-arm-kernel/2015-October/374377.html
Changes since v1:
- The voltage scaling patch (AXP209 PMU regulators) has been already
applied by Maxime, so it is not included in this patch set anymore.
- A new patch with a separate dts for pcDuino2 has been added,
as had been requested during the previous review round.
- Instead of removing "usb1_vbus-supply" and "usb2_vbus-supply",
they now refer to "reg_vcc5v0" (this had been discussed on IRC).
Siarhei Siamashka (3):
ARM: dts: sun4i: Allow to use the PH6 pin for GPIO on pcDuino1/2
ARM: sun4i: dt: Add new LinkSprite pcDuino2 board
ARM: dts: sun4i: Enable USB DRC on pcDuino1/2
arch/arm/boot/dts/Makefile | 3 +-
arch/arm/boot/dts/sun4i-a10-pcduino.dts | 29 ++++++++----
arch/arm/boot/dts/sun4i-a10-pcduino2.dts | 78 ++++++++++++++++++++++++++++++++
3 files changed, 100 insertions(+), 10 deletions(-)
create mode 100644 arch/arm/boot/dts/sun4i-a10-pcduino2.dts
--
2.4.9
--
You received this message because you are subscribed to the Google Groups
"linux-sunxi" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
