nand_dt_init(), called from nand_scan_ident(), is already parsing the generic MTD/NAND DT properties, and initializing the nand_chip struct accordingly. Rely on this initialization instead of manually parsing those properties.
Signed-off-by: Boris Brezillon <[email protected]> --- drivers/mtd/nand/sunxi_nand.c | 18 +++++------------- 1 file changed, 5 insertions(+), 13 deletions(-) diff --git a/drivers/mtd/nand/sunxi_nand.c b/drivers/mtd/nand/sunxi_nand.c index f97a58d..6bd7099 100644 --- a/drivers/mtd/nand/sunxi_nand.c +++ b/drivers/mtd/nand/sunxi_nand.c @@ -1166,12 +1166,7 @@ static int sunxi_nand_ecc_init(struct mtd_info *mtd, struct nand_ecc_ctrl *ecc, int blk_size; int ret; - blk_size = of_get_nand_ecc_step_size(np); - strength = of_get_nand_ecc_strength(np); - if (blk_size > 0 && strength > 0) { - ecc->size = blk_size; - ecc->strength = strength; - } else { + if (!ecc->size) { ecc->size = nand->ecc_step_ds; ecc->strength = nand->ecc_strength_ds; } @@ -1181,10 +1176,6 @@ static int sunxi_nand_ecc_init(struct mtd_info *mtd, struct nand_ecc_ctrl *ecc, ecc->mode = NAND_ECC_HW; - ret = of_get_nand_ecc_mode(np); - if (ret >= 0) - ecc->mode = ret; - switch (ecc->mode) { case NAND_ECC_SOFT_BCH: break; @@ -1310,15 +1301,13 @@ static int sunxi_nand_chip_init(struct device *dev, struct sunxi_nfc *nfc, /* Default tR value specified in the ONFI spec (chapter 4.15.1) */ nand->chip_delay = 200; nand->controller = &nfc->controller; + nand->dn = np; nand->select_chip = sunxi_nfc_select_chip; nand->cmd_ctrl = sunxi_nfc_cmd_ctrl; nand->read_buf = sunxi_nfc_read_buf; nand->write_buf = sunxi_nfc_write_buf; nand->read_byte = sunxi_nfc_read_byte; - if (of_get_nand_on_flash_bbt(np)) - nand->bbt_options |= NAND_BBT_USE_FLASH | NAND_BBT_NO_OOB; - mtd = &chip->mtd; mtd->dev.parent = dev; mtd->priv = nand; @@ -1328,6 +1317,9 @@ static int sunxi_nand_chip_init(struct device *dev, struct sunxi_nfc *nfc, if (ret) return ret; + if (nand->bbt_options & NAND_BBT_USE_FLASH) + nand->bbt_options |= NAND_BBT_NO_OOB; + ret = sunxi_nand_chip_init_timings(chip, np); if (ret) { dev_err(dev, "could not configure chip timings: %d\n", ret); -- 1.9.1 -- You received this message because you are subscribed to the Google Groups "linux-sunxi" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
