Hi Haibo,
On 06/10/2015 01:50 AM, Haibo Chen wrote:
> i.MX7D support eMMC HS400 mode, this mode can run in 8 bit,200MHZ
> DDR mode. So the I/O speed improve a lot compare to SD3.0
>
> The default burst length is 8, if we don't change this value, in
> HS400 mode, when we do eMMC read operation, we can find that the
> clock signal will stop for a period of time. This means the speed
> of data moving on AHB bus is slower than I/O speed. So we should
> improve the speed of data moving on AHB bus.
>
> For imx7d usdhc, this patch set the burst length as 16, and set
> watermater levle as 64. The test result is the clock signal has
> no stop during the eMMC HS400 operation. For other imx usdhc, remain
"watermark", not "watermater".
> the default value: burst length as 8, watermater level as 16.
>
Same goes for the subject.
Also "levels", not "levles", so:
mmc: sdhci-esdhc-imx: config watermark level and burst length
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
