> + that embeds only one SD/MMC slot. > + > +config MACH_AT91SAM9G20EK_2MMC > + bool "Atmel AT91SAM9G20-EK Evaluation Kit with 2 SD/MMC Slots" > + depends on ARCH_AT91SAM9G20 > + help > + Select this if you are using an Atmel AT91SAM9G20-EK Evaluation Kit > + with 2 SD/MMC Slots. This is the case for AT91SAM9G20-EK rev. C and > + onwards. > > config MACH_CPU9G20 > bool "Eukrea CPU9G20 board" > @@ -392,7 +394,7 @@ config MTD_AT91_DATAFLASH_CARD > > config MTD_NAND_ATMEL_BUSWIDTH_16 > bool "Enable 16-bit data bus interface to NAND flash" > - depends on (MACH_AT91SAM9260EK || MACH_AT91SAM9261EK || > MACH_AT91SAM9G10EK || MACH_AT91SAM9263EK || MACH_AT91SAM9G20EK || > MACH_AT91SAM9G45EKES || MACH_AT91CAP9ADK) > + depends on (MACH_AT91SAM9260EK || MACH_AT91SAM9261EK || > MACH_AT91SAM9G10EK || MACH_AT91SAM9263EK || MACH_AT91SAM9G20EK || > MACH_AT91SAM9G20EK_2MMC || MACH_AT91SAM9G45EKES || MACH_AT91CAP9ADK) it's time to replace this by select it at machine config state
> @@ -254,7 +257,11 @@ static void __init ek_board_init(void) > /* Ethernet */ > at91_add_device_eth(&ek_macb_data); > /* MMC */ > +#if defined(CONFIG_MMC_ATMELMCI) || defined(CONFIG_MMC_ATMELMCI_MODULE) > at91_add_device_mci(0, &ek_mmc_data); > +#else > + at91_add_device_mmc(0, &ek_mmc_data); > +#endif do we really need to do this choice at board level? Best Regards, J. -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
