Hello.

On 31-03-2014 1:26, Ben Dooks wrote:

Add support for devicetree probe for the rcar-vin
driver.

Signed-off-by: Ben Dooks <ben.do...@codethink.co.uk>
---
  .../devicetree/bindings/media/rcar_vin.txt         | 79 ++++++++++++++++++++++
  drivers/media/platform/soc_camera/rcar_vin.c       | 67 ++++++++++++++++--
  2 files changed, 140 insertions(+), 6 deletions(-)
  create mode 100644 Documentation/devicetree/bindings/media/rcar_vin.txt

diff --git a/Documentation/devicetree/bindings/media/rcar_vin.txt 
b/Documentation/devicetree/bindings/media/rcar_vin.txt
new file mode 100644
index 0000000..105b8de
--- /dev/null
+++ b/Documentation/devicetree/bindings/media/rcar_vin.txt
@@ -0,0 +1,79 @@
+Renesas RCar Video Input driver (rcar_vin)
+------------------------------------------
+
+The rcar_vin device provides video input capabilities for the Renesas R-Car
+family of devices. The current blocks are always slaves and suppot one input
+channel which can be either RGB, YUYV or BT656.
+
+ - compatible: Must be one of the following
+   - "renesas,vin-r8a7791" for the R8A7791 device
+   - "renesas,vin-r8a7790" for the R8A7790 device
+   - "renesas,vin-r8a7779" for the R8A7779 device
+   - "renesas,vin-r8a7778" for the R8A7778 device
+ - reg: the register base and size for the device registers

   Register base of the registers?

[...]
+/* composite video input */
+&vin1 {
+        pinctrl-0 = <&vin1_pins>;
+        pinctrl-names = "default";
+
+        status = "ok";
+
+        port {
+                #address-cells = <1>;

   Where is this used? I don't see "reg" prop in the sub-node...

+                #size-cells = <0>;
+
+                vin1ep0: endpoint {
+                        remote-endpoint = <&adv7180_1>;
+                        bus-width = <8>;
+                };
+        };
+};
+
+
+
+[1] video-interfaces.txt common video media interface
diff --git a/drivers/media/platform/soc_camera/rcar_vin.c 
b/drivers/media/platform/soc_camera/rcar_vin.c
index 47516df..73c56c7 100644
--- a/drivers/media/platform/soc_camera/rcar_vin.c
+++ b/drivers/media/platform/soc_camera/rcar_vin.c
[...]
@@ -1392,6 +1395,17 @@ static struct soc_camera_host_ops rcar_vin_host_ops = {
        .init_videobuf2 = rcar_vin_init_videobuf2,
  };

+#ifdef CONFIG_OF

I don't think it's worth using this #ifdef -- the OF code is not under #ifdef anyway...

+static struct of_device_id rcar_vin_of_table[] = {
+       { .compatible = "renesas,vin-r8a7791", .data = (void *)RCAR_GEN2 },
+       { .compatible = "renesas,vin-r8a7790", .data = (void *)RCAR_GEN2 },
+       { .compatible = "renesas,vin-r8a7779", .data = (void *)RCAR_H1 },
+       { .compatible = "renesas,vin-r8a7778", .data = (void *)RCAR_M1 },
+       { },
+};
+MODULE_DEVICE_TABLE(of, rcar_vin_of_table);
+#endif
+
  static struct platform_device_id rcar_vin_id_table[] = {
        { "r8a7791-vin",  RCAR_GEN2 },
        { "r8a7790-vin",  RCAR_GEN2 },
@@ -1404,15 +1418,50 @@ MODULE_DEVICE_TABLE(platform, rcar_vin_id_table);

  static int rcar_vin_probe(struct platform_device *pdev)
  {
+       const struct of_device_id *match = NULL;
        struct rcar_vin_priv *priv;
        struct resource *mem;
        struct rcar_vin_platform_data *pdata;
+       unsigned int pdata_flags;
        int irq, ret;

-       pdata = pdev->dev.platform_data;
-       if (!pdata || !pdata->flags) {
-               dev_err(&pdev->dev, "platform data not set\n");
-               return -EINVAL;
+       if (pdev->dev.of_node) {
+               struct v4l2_of_endpoint ep;
+               struct device_node *np;
+
+               match = of_match_device(of_match_ptr(rcar_vin_of_table),
+                                       &pdev->dev);
+
+               np = v4l2_of_get_next_endpoint(pdev->dev.of_node, NULL);
+               if (!np) {
+                       dev_err(&pdev->dev, "could not find endpoint\n");
+                       return -EINVAL;
+               }
+
+               ret = v4l2_of_parse_endpoint(np, &ep);
+               if (ret) {
+                       dev_err(&pdev->dev, "could not parse endpoint\n");
+                       return ret;
+               }
+
+               if (ep.bus_type == V4L2_MBUS_BT656)
+                       pdata_flags = RCAR_VIN_BT656;
+               else {

   Need {} in all arms of this *if* statement.

[...]
@@ -1447,8 +1496,13 @@ static int rcar_vin_probe(struct platform_device *pdev)
        priv->ici.drv_name = dev_name(&pdev->dev);
        priv->ici.ops = &rcar_vin_host_ops;

-       priv->pdata_flags = pdata->flags;
-       priv->chip = pdev->id_entry->driver_data;
+       priv->pdata_flags = pdata_flags;
+       if (!match)
+               priv->chip = pdev->id_entry->driver_data;
+       else
+               priv->chip = (enum chip_id)match->data;
+
+

   Too many empty lines.

@@ -1489,6 +1543,7 @@ static struct platform_driver rcar_vin_driver = {
        .driver         = {
                .name           = DRV_NAME,
                .owner          = THIS_MODULE,
+               .of_match_table = of_match_ptr(rcar_vin_of_table),

   Don't think we need of_match_ptr() as well as #ifdef CONFIG_OF.

[...]

WBR, Sergei

--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majord...@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Reply via email to