The Realtek Kernel driver uses the second DVB-T 7MHz table instead
of the first one. Use it as well.
Signed-off-by: Mauro Carvalho Chehab <mche...@redhat.com>
---
drivers/media/tuners/r820t.c | 12 ++++++++++--
1 file changed, 10 insertions(+), 2 deletions(-)
diff --git a/drivers/media/tuners/r820t.c b/drivers/media/tuners/r820t.c
index 79ab2b7..1880807e 100644
--- a/drivers/media/tuners/r820t.c
+++ b/drivers/media/tuners/r820t.c
@@ -915,6 +915,14 @@ static int r820t_set_tv_standard(struct r820t_priv *priv,
flt_ext_widest = 0x00; /* r15[7]: flt_ext_wide off */
polyfil_cur = 0x60; /* r25[6:5]:min */
} else if (bw == 7) {
+#if 0
+ /*
+ * There are two 7 MHz tables defined on the original
+ * driver, but just the second one seems to be visible
+ * by rtl2832. Keep this one here commented, as it
+ * might be needed in the future
+ */
+
if_khz = 4070;
filt_cal_lo = 60000;
filt_gain = 0x10; /* +3db, 6mhz on */
@@ -926,7 +934,8 @@ static int r820t_set_tv_standard(struct r820t_priv *priv,
lt_att = 0x00; /* r31[7], lt att enable */
flt_ext_widest = 0x00; /* r15[7]: flt_ext_wide off */
polyfil_cur = 0x60; /* r25[6:5]:min */
-#if 0 /* 7 MHz type 2 - nor sure why/where this is used - Perhaps Australia? */
+#endif
+ /* 7 MHz, second table */
if_khz = 4570;
filt_cal_lo = 63000;
filt_gain = 0x10; /* +3db, 6mhz on */
@@ -938,7 +947,6 @@ static int r820t_set_tv_standard(struct r820t_priv *priv,
lt_att = 0x00; /* r31[7], lt att enable */
flt_ext_widest = 0x00; /* r15[7]: flt_ext_wide off */
polyfil_cur = 0x60; /* r25[6:5]:min */
-#endif
} else {
if_khz = 4570;
filt_cal_lo = 68500;
--
1.8.1.4
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
